K4M engine power supply system Renault Duster 1

Intake tract scheme
1 - Air intake pipe 2 - Intake muffler 3 - Air filter housing 4 - Air filter 5 - Throttle valve block 6 - Intake manifold 7 - Injector body lining 8 - Air start

Intake muffler
Removing Remove: fastening tape (1) intake silencer, intake silencer (2). Installation Install: intake silencer, intake silencer housing tape.

Air filter
Removing Remove the intake silencer. Disconnect the suction hose of the vacuum (1) brake booster from the intake manifold. Attention! Be careful not to damage the suction pipe on the intake manifold. If the pipe is...

Air filter housing
Tightening torques: Air filter housing mounting bolts - 9 Nm. Removing Disconnect the battery. Remove the intake silencer. Disconnect: wiring block (1) idle speed controller stepper motor, wiring block (2) throttle...

Throttle block
Tightening torques: Throttle valve mounting bolts - 13 Nm. Removing Disconnect the battery. Remove the air filter housing. Disconnect the throttle cable at the point (1). Remove: fastening bolts (2) throttle block,...

Intake manifold
Tightening torques: Intake manifold mounting bolts - 9 Nm. Removing Disconnect at a point (1) throttle cable from the throttle body. Remove the throttle cable (2) from the intake manifold. Disconnect: block of wires...

Injector body lining
Tightening torques bolts (7) And (8) nozzle body linings 25 Nm Bolts 9 and 16 of the lining of the injector housings 21 Nm Bolt of fastening of the top cover of the drive GRM 41 Nm Suspension Support Bolt 62 Nm Removing...

An exhaust manifold
Tightening torques Exhaust manifold studs 8 Nm Nuts of hairpins of fastening of a final collector 23 Nm Mounting bolt (6) strut on the cylinder block 21 Nm stud nut (7) exhaust manifold brace 21 Nm Exhaust manifold...