Removal and installation of a radiator

To remove the radiator (left engine type «WITH», right engine type «F») it is necessary to unscrew both mounting bolts on the left and right and remove it from the rubber supports (shown by arrows). First you need to drain the coolant and remove the radiator hoses from above and below. Be sure to disconnect the thermal switch and fan connectors so that the patch does not burst from high pressure. While driving, carefully monitor the coolant temperature readings and the coolant overheat warning light.


1. If necessary, remove the air filter.

2. Drain coolant.

3. Remove the upper and lower radiator hoses.

4. Disconnect the thermoswitch and engine cooling fan connectors.

5. Remove the engine cooling fan with the air supply device.

6. Unscrew the nuts of the radiator holders on both sides in the upper part of its mounting and deflect the holders so that the rubber radiator supports come out of them.

7. Tilt the radiator back a little and remove it from the engine compartment.

8. When installing, make sure that the lower guide pins are in the correct position in the rubber bearings of the cross beam.