Electrical equipment and appliances Renault Fluence 1

Electrical equipment — general information
The electrical equipment system consists of a storage battery, a generator, a starter, electricity consumers and electrical circuits. Lighting fixtures include headlights, taillights, fog lights, direction and signal...

Determination of the source of electrical equipment malfunction
The electrical circuit consists of an electrical element, switches, relays, electric motors, fuses, automatic switches, wires and connectors that connect the current consumer to the battery and body. To help you...

Exterior mirrors
Remove a decorative overlay of an external rear-view mirror (1). Disconnect connector (2). Remove the screws (3) and outside rearview mirror (4). Install the parts in reverse order. Mirror glass Protect mirror edges (1)...

Interior rear view mirror
Remove: top cover (1) with upholstery removal lever (Car. 1363); bottom cover (2). Disconnect connector (4) interior temperature sensor. Disconnect connector (5) rain and light sensor (if installed). Remove the interior...

External rearview mirror switch
External rear view mirror electric drive switch (1) replaced as an assembly with driver's side front door power window switch panel (see related description).

Instrument lighting dimmer
Since the instrument light dimmer cannot be separated from the headlight range control switch, replace the entire unit if necessary (see related description).

Hazard and central locking switch
Switch off the ignition. Detach the central ventilation nozzle using the upholstery removal lever (Car. 1363) (1) pressing the latches (2). Disconnect the hazard warning and central locking switch connector. Disconnect...

Windscreen wiper arm
Note. To ensure the correct trajectory of the wiper arms, it is necessary to initialize the wiper motor after replacing the arms. Turn the windshield wiper switch sequentially from position (0) into position (1), then...

Windscreen wiper mechanism
Remove: windshield wiper arms; air intake grille (see related description). Remove mounting bolts (1) box amplifier under the grille of the air intake niche. Remove: bolts (2) fastening the windshield wiper mechanism;...

Windshield wiper motor
Remove: windshield wiper arms; air intake grille (see corresponding description); box under the grate of the air intake niche (see corresponding description). Disconnect connector (1) wiper motor. Remove: bolts (2)...

Rear window wiper arm
Turn on the ignition. Turn the windshield wiper switch sequentially from position (0) into position (1), then back to position (0). Remove the nut cap. Loosen the wiper arm nuts. Remove the rear window wiper arm using a...

Rear window cleaner electric motor
Remove: rear window wiper lever; tailgate upholstery. Disconnect connector (1) rear window wiper motor. Remove the rivets (2) rear window wiper motor mounts. Install the parts in reverse order.

Rain and light sensor
Switch off the ignition. Remove the cover under the interior rear view mirror. Disconnect connector (1) rain and light sensor. Detach the two side clips (2) rain and light sensor using the upholstery removal lever tool...

Glass washer reservoir
Place the car on a lift. Remove: front wheels; front fenders; front bumper; windshield washer bottle neck. To do this, disconnect the windshield washer bottle neck at the point (1). Note. When removing the washer pump,...

Instrument cluster
Switch off the ignition. Set the steering column to the down position. Insert fixture (Ms. 1872) on each side of the instrument cluster, as shown in the figure, at the point (1). Press lightly (2) on both tools towards...

Driver's door wiring harness
Raise the glass. Switch off the ignition. Disconnect the battery. Remove (operation description see section « Body »): upholstery of the front door; sealing film of the front door; front door side impact sensor; front...

Front passenger door wiring harness
Attention. To prevent problems from occurring (noise, premature wear, short circuit, etc.) after installation, mark the wiring harness route and the isolation of the connectors. Unlock at the point (6) front door...

Rear door wiring harness (Megane III)
Note. The left and right door wiring is the same. Raise the glass. Switch off the ignition. Disconnect the battery. Remove (operation description see section 8 «Body»): upholstery of the rear side door; rear door seals....

Dashboard Wiring Harness (Megane III)
Connectors: circuits between instrument panel wiring harness and rear wiring harness R2 (1); circuits between instrument panel wiring harness and rear wiring harness R423 (2); circuits between instrument panel wiring...

Wiring harness front of the car (Megane III)
Connectors: circuits between dashboard wiring harness and R107 front engine wiring harness (8); circuits between vehicle front wiring harness and left rear wiring harness R374 (9); circuits between the wiring harness of...

Rear wiring harnesses (Megane III)
Connector R 319 (1) (circuit between rear bumper and rear wiring harness). Rear wiring harnesses (Megane III)

Renault card reader
Switch off the ignition. Remove the center panel. Remove the card reader (2), by pressing the holders (1) with a small flat blade screwdriver. Disconnect the card reader connector.

Engine start button
Switch off the ignition. Remove the center panel. Disconnect the engine start button connector. Remove the engine start button by depressing the spring latches (1).