Automatic transmission (FK0 — Megane III, DP0 — Fluence) General information Vehicles with automatic transmissions are equipped with systems «Shift lock and lock up». System «Shift Lock» blocks the movement of the selector lever if the brake pedal is not pressed at the same...
Safety precautions when working with automatic transmissions 1. The automatic transmission 1 final drive is made up of high precision parts, which requires careful inspection before reassembly, because even a small scratch may cause fluid leakage or affect performance. Repair...
Transmission fluid Applied liquid The oil is filled into the automatic transmission for the entire period of operation. Therefore, it does not require maintenance. In the case of small leaks, only topping up the oil is carried out. Oil...
Assignment of the diagnostic contacts of the DP0 gearbox control unit Fill the gearbox with fluid and check the level. Filling with automatic transmission fluid Filling is carried out through the appropriate opening (1). Use a 15/1 mesh filter funnel to prevent contamination. Park the...
Checking torque converter lockup Place the car on a lift. Raise the car until the wheels are off the floor by a few centimeters. Connect the diagnostic tool («CLIP»). Enter into a dialogue with the automatic transmission computer. Monitor the oil...
Pressure measurement in the pressure line Necessary fixtures and special tools: special tool Bvi. 1215-01; automatic transmission oil pressure test kit (in a case); pressure gauge 25 bar. Some automatic transmission diagnostic procedures require the pressure in...
Removal and installation of the hydrodistributor Automatic transmission oil pan Remove the engine undertray. Drain the oil from the automatic transmission. Remove: bolts for fastening the oil pan (1); automatic transmission oil pan (2); laying of the pallet crankcase;...
Multifunction lever Adjustment Loosen the mounting bolts (1) multifunction switch. Set hex wrench to 3mm (2) on the drive lever and align the axis of the tool with the hole in the multifunction switch (3). Torque tighten the multifunction...
Vehicle speed and torque converter turbine rotation sensors Place the car on a lift. Disconnect the battery. Remove the engine undertray. Torque Converter Turbine Speed Sensor Disconnect connector (1) torque converter turbine speed sensor. Remove: torque converter turbine speed...
Removal and installation of an automatic transmission Attention. To prevent breakage of the contact disc under the steering wheel, the following instructions must be observed: before disconnecting the steering shaft from the steering mechanism, be sure to block the...
ECU automatic transmission — replacement Place the car on a lift. Disconnect the battery. Remove: right front wheel; right front fender. Disconnect connector (1) ECU for automatic transmission. Remove: automatic transmission computer mounting nuts (2); ECU...