Remove the clutch cover with pressure plate assembly.
Install retainer (Mot. 582-01) (1).
Remove the flywheel mounting bolts, remove the flywheel and retainer (Mot. 582-01).
Install retainer (Mot. 1677) (1) Remove the flywheel mounting bolts, remove the flywheel and retainer (Mot. 1677).
Clean the threaded holes on the crankshaft flange for the flywheel mounting bolts.
Degrease the bearing surface of the flywheel on the crankshaft flange. Check the condition of the flywheel.
Install spacer (1), while observing the installation direction: chamfered towards the flywheel.
 |  |
Attention. Removed bolts must not be reused.
Coat the new flywheel bolts with «Loctite frenetanch».
Tighten in the order shown in the figure to the required torque:
- flywheel bolts (engines K) (65 Nm);
- flywheel bolts (M4R engine) (70 Nm).
Flywheel tightening procedure