Removing
Remove the wheel drive shaft from the corresponding side.
Remove covers of shaft of a drive of wheels.
Press the coarse vibration damper A with a press, using a puller as a support.
Saw through the large and small clamps, being careful not to damage the grooves of the hinge housing and drive shaft.
Cut the cover along its entire length. Remove as much grease as possible.
Attention! Make sure that the blows are applied to the rocky end of the clip, and not to the treadmills of the balls.
Using a hammer and punch, apply a few blows to the yoke to disengage the pivot housing from the drive shaft.
Remove the retaining ring and protective cover.
Installation
Attention! But use solvents to clean the hinge parts.
Note. Observe the amount of lubricant put into the hinge, indicated in table 3.1.
Table 3.1 Amount of recommended lubrication of the drive mechanism joints
Put on a cover on a power shaft from outside a transmission.
Apply some T857740131 grease to the coarse vibration damper bore.
Using a press, press the coarse vibration damper onto the wheel drive shaft until the dimension L = 221 mm + 3 is obtained.
Lightly lubricate the wheel drive shaft to facilitate installation of the protective boot.
Install on the drive shaft:
- clamp of small diameter;
- protective case;
- new retaining ring.
Tapping with a brass drift on the hinge body, insert the clip so. so that the retaining ring snaps into place behind the cage.
Attention! The retaining ring must be replaced every time the hinge housing is removed.
Fill boot and outer pivot housing with equal amounts of grease.
Position the edges of the protective boot in the grooves of the pivot housing and drive shaft.
Rock the CV joint by hand to check that the boot bands are properly installed.
Insert a rounded rod between the boot and hinge body to adjust the amount of air inside the hinge.
Install a large clamp.
Tighten the small and large clamps on the cover until they snap into place using the tool (Tav. 1168).
Crimp the clamps.
Place spacer A in the lower cutouts and squeeze the pliers until it stops. The pre-swaged collar can slide over the protective boot. Position it in the right place.
Place spacer A in the top notch and squeeze the pliers until it stops.
Install the wheel drive shaft on the appropriate side.