Note:
- Be sure to replace the outer differential seal and clutch thrust bearing with new ones after each removal.
- Do not lubricate input shaft splines to install clutch disc.
- Make sure the dowel pins are in place in the gearbox.
1. If installing a new gearbox, install a reverse switch on it.
2. Install the outer differential seal.
3. Install the clutch release fork.
4. Install the clutch thrust bearing.
5. Using a garage jack, raise the gearbox to its place in the car.
6. To establish bolts and nuts of fastening of a transmission.
7. Install the flywheel cover and hand-tighten its fastening bolts.
8. Remove the garage jack from under the gearbox.
9. Tighten the gearbox mounting nuts to 44 Nm.
10. Install starter.
11. Tighten the gearbox mounting bolts to 44 Nm.
12. Tighten the flywheel cover bolts to 44 Nm.
13. To establish the tire of weight and to tighten a bolt of fastening the moment of 44 Нм.
14. Further installation is carried out in the reverse order of removal.
15. Fill the gearbox with gear oil.
16. Fill and bleed the power steering hydraulic circuit.