Install the jig into the plate (the end of the conductor must enter the hole for the nozzle) to center the plate.
Pic. 2.158. Installing the injector for cylinders 2 and 4: 1 - bolts; 2 - special device; 3 - conductor
Tighten the two mounting bolts. Pull out the jig (pic. 2.158).
Install the mandrel instead of the conductor. Insert the nozzle into the mandrel.
Attention! When installing the nozzle, its tip should be directed towards the center of the cylinder.
Pic. 2.159. Nozzle rolling: 1 - conductor; 2 - bead
Apply several blows with a hammer on the mandrel until the mandrel flange touches the support (pic. 2.159).
Pic. 2.160. Checking the correct installation of the nozzles
Check that the nozzles for cooling the piston heads are correctly oriented. Mark A corresponds to the injectors of cylinders 2 and 4, and mark B corresponds to the injectors of cylinders 1 and 3 (pic. 2.160).