Attention! Handle the clutch pedal travel sensor with care.
It is allowed to move the stem only when adjusting the size X (see fig. 3.9).
Pic. 3.9. Clutch pedal travel sensor: 1 – sensor housing; 2 - rod
Disconnect the clutch pedal travel sensor connector.
Turn the clutch pedal travel sensor 1/4 turn counterclockwise.
Remove the clutch pedal travel sensor.
The clutch pedal travel sensor must be replaced if the stem separated from the sensor or more than three size changes were required for adjustment X.
measure size X stem protrusion. If the X dimension is less than 17 mm, adjust it by gently pulling on the stem end. Size X must be within 17 mm (at least) up to 18 mm (no more).
Press the clutch pedal by hand.
Install the clutch pedal travel sensor to the pedal assembly.
Lock the clutch pedal travel sensor by turning it 1/4 turn clockwise.
When returning the clutch pedal to its original position, support it with your hand.
Note. The clutch pedal travel sensor adjusts automatically depending on the position of the pedal.
During automatic adjustment, clicks are heard when passing through the fixed positions.
Connect the connector.