Passive safety system of car Renault Sandero 1

Passive safety system
Passive safety system (SRS) The Renault/Dacia Sandero car combines front airbags for the driver and front passenger (installed depending on the vehicle configuration), as well as seat belts for the driver and all...

Removing and installing the driver's airbag
The driver's airbag must be removed when repairing the steering components and electrical equipment of the vehicle, so the process of its removal and installation is described in this manual. However, to avoid injury,...

Replacing the front seat belts
Note: The front seat belt replacement is shown using the driver's seat belt as an example. The front passenger seat belt is replaced in the same way. You will need: TORX keys T20, T40, «at 16», «at 17». 1. If the seat...

Replacing rear seat belts
You will need: keys «at 16», «at 17», TORX T25, flat blade screwdriver. 1. To remove the rear side passenger seat belt, unscrew the two screws securing the plastic trim to the vehicle body. 2. Remove the plastic trim...

Removal and installation of the electronic control unit of the passive safety system
You will need: all the tools needed to remove the field tunnel lining, as well as a wrench «by 10». 1. Disconnect the wire from the terminal «minus» battery. 2. Remove the floor tunnel lining (see « Removing and...

Anti-lock braking system
Depending on the configuration, Renault/Dacia Sandero cars are equipped with an anti-lock braking system (ABS). The system consists of wheel speed sensors, a brake light switch, a hydro-electronic control module and a...