General body description and precautions RENAULT MEGANE/SCENIC cars have a load-bearing body. The base of the body, its side parts, roof and rear fenders are welded together. Therefore, serious body repairs should be entrusted to the workshop. The hood, trunk...
Front bumper — removal, installation, disassembly Removing 2.0 Front bumper components 1. Cars with fog lights. Disconnect wire terminal «masses» (-) from the battery. Attention! In this case, some data is deleted from the memory of some blocks, for example, the...
Rear bumper — removal and installation Removing 1. Mark with paint the position of the rear wheels on the hubs. This will allow the assembly to set the balanced wheel in its original position. 2. Loosen the wheel bolts. In this case, the car must be on...
Radiator grill — removal and installation The radiator grill is two-piece. The procedure for removing the grille is shown in the example of dismantling one half. The second half of the grille is removed in an identical way. Removing 1. Remove forward indexes of...
Fairing — removal and installation The fairing is located under the windshield and consists of two halves. Removing 1. Remove the glass cleaner arms, see the relevant chapter. 2. Remove, by pulling up, the sealing gum A (see illustration). 5.2 Pull up...
Front fenders — removal and installation Removing 1. Remove fairing. 2. Remove forward indexes of turn, and also lateral repeaters, the corresponding chapter see. 3. Remove the front bumper. 4. Remove the fender liner by unscrewing the mounting bolts with a...
Hood and hood lock — removal, installation, fitting An assistant is needed to remove the hood. The hood hinge can be detached without removing the hood. When installing the old hood, its adjustment is not required. Removing 1. Open the hood and disconnect the washer...
Hood lock cable — removal and installation Removing 1. Remove the left half of the grille. 2. Remove an overlay of a threshold from the driver's party, the corresponding chapter see. 3. Remove the hood lock, having previously marked the mounting position of the...
Decorative overlay (molding) trunk lids Removing 1. Remove cover trim. 2. Remove the license plate light mounting bolts and disconnect the wire. 3. Unscrew the two nuts A of the molding fastening, as well as the nuts B of the lock switch (see illustration)....
Side moldings — removal and installation Removing 1. Open the door. 2. Unscrew the bolt on the door frame (see arrow in illustration). 13.2 Unscrew the bolt on the door frame (see arrow) 3. Move the molding forward in the direction of the arrow I (see...
Roof trim strips — removal and installation Removing 1. Turn the bar by hand in the direction of the arrow, as shown in the illustration, and release it from the holders. Do not bend the bar at the same time, because it will remain deformed for a long time....
Rear spoiler — removal and installation Cars with a body «coupe» Removing 1. Open the trunk lid and unscrew the bolts D (see illustration). 1S.1 Open the boot lid and unscrew the bolts D Installation 2. Drill holes in the trunk lid if a new lid is installed....
Exterior mirrors Removing 1. Remove the trim from the door by prying it with a wide screwdriver (see illustration). 24.1 Remove the trim from the door by prying it with a wide screwdriver 2. Remove the front mounting bolt cap and also...
Glass of an external rear-view mirror — removal and installation Attention! The mirror glass can be replaced without removing the mirror itself. Removing 1. Tilt the mirror housing forward. 2. Insert a suitable spatula or wedge between the glass and the mirror housing, eg FACOM Car....