Diesel engine power system Renault Scenic 1

Diesel engine power specifications
Components Type of injection pump Notes High pressure fuel pump, for an F8Q engine with a power of 64 hp. Saugd icsel power system BOSCH R598 distribution type, alternative to ROTO DIESEL Distribution injection pump...

Working principle of diesel engine
In diesel engines, clean air enters the cylinders and is highly compressed there. Because of this, the temperature in the cylinders becomes higher than the ignition temperature of diesel fuel. At the moment when the...

Glow plugs — check
The preheating device must be checked in cases where a cold engine is bad. starts. Attention! Difficulties when starting a cold engine can also be due to low compression. Therefore, in such cases, the compression should...

Fuel System — Bleeding
As a general rule, the fuel system does not need to be bled, even if the fuel tank has been completely emptied or parts of the fuel system have been replaced. Air from system is removed automatically during start of the...

Idle speed (diesel 64 hp) — checking and adjusting
Vehicles with a 64 hp diesel engine (with injection pump BOSCH). Properly adjusted idle speed is essential for a diesel engine. An engine with incorrectly set speeds runs intermittently at idle or during acceleration....

Idle speed (diesel 90 hp) — checking and adjusting
Vehicles with a 90 hp turbocharged diesel engine. (with injection pump LUCAS). Properly adjusted idle speed is essential for a diesel engine. An engine with incorrectly set speeds runs intermittently at idle or during...

Idle speed (diesel 98 hp) — examination
Vehicles with a 98 hp direct injection engine. and turbocharger (BOSCH injection pump) The idle speed of these engines cannot be adjusted on their own. If the idle speed ratings listed below are not maintained, have the...

Fuel injectors — removal and installation
Vehicles with a 64/90n.c. diesel engine. (F8Q) Faulty injectors can cause severe knocking in the engine, which is usually a sign of defective bearings. With such malfunctions, start the engine at idle and loosen the...